Health & Saf. Code, § 44013 · Article 2. Program Requirements
Health & Saf. Code, § 44013
Text — As published in the Legislative Counsel's database, tables dated October 18, 2026 (pubinfo_2025.zip)
(a) (1) The department, in cooperation with the state board, shall prescribe maximum emission standards to be applied in inspecting motor vehicles under this chapter.
(2) In prescribing the standards, the department shall undertake studies and experiments which are necessary and feasible, evaluate available data, and confer with automotive engineers.
(3) The standards shall be set at a level reasonably achievable for each class and model of motor vehicle when operating in a reasonably sound mechanical condition, allowing for the effects of installed motor vehicle pollution control devices and the motor vehicle’s age and total mileage.
(4) The standards shall be designed so that motor vehicles failing the test specified in Section 44012 will be operated, as soon as possible, with a substantial reduction in emissions, and shall be revised from time to time as experience justifies.
(b) The department, in cooperation with the state board, shall research and prescribe test procedures to be applied in inspecting motor vehicles under this chapter, which procedures shall be simple, cost-effective, and consistent with Section 44012. The department may revise the test procedures from time to time as experience justifies. To the extent that any test procedure revision requires new equipment, or a change in equipment, at licensed smog check stations, the department shall provide a reasonable period of time for the acquisition and installation of that new or changed equipment.
(c) Notwithstanding any other provision of this chapter, the maximum emission standards and test procedures prescribed in subdivisions (a) and (b) for a motor vehicle class and model-year shall not be more stringent than the emission standards and test procedures under which that motor vehicle’s class and model-year was certified. Emission standards and test procedures prescribed by the department shall ensure that not more than 5 percent of the vehicles or engines, which would otherwise meet the requirements of this part, will fail the inspection and maintenance test for that class of vehicle or engine.
Notes and commentary — not statutory text
History
Amended by Stats. 1994, Ch. 27, Sec. 15. Effective March 30, 1994. Superseded on operative date of amendment by Stats. 1994, Ch. 1192.
Another version listed by the Legislative Counsel
Inoperative five years from operative date. Repealed on January 1 after inoperative date, by its own provisions. See later operative version added by Sec. 22.5 of Ch. 1192.
(a) (1) The department, in cooperation with the state board, shall prescribe maximum emission standards to be applied in inspecting motor vehicles under this chapter.
(2) In prescribing the standards, the department shall undertake studies and experiments which are necessary and feasible, evaluate available data, and confer with automotive engineers.
(3) The standards shall be set at a level reasonably achievable for each class and model of motor vehicle when operating in a reasonably sound mechanical condition, allowing for the effects of installed motor vehicle pollution control devices and the motor vehicle’s age and total mileage.
(4) The standards shall be designed so that motor vehicles failing the test specified in Section 44012 will be operated, as soon as possible, with a substantial reduction in emissions, and shall be revised from time to time as experience justifies.
(b) The department, in cooperation with the state board, shall research and prescribe test procedures to be applied in inspecting motor vehicles under this chapter, which procedures shall be simple, cost-effective, and consistent with Section 44012. The department may revise the test procedures from time to time as experience justifies. To the extent that any test procedure revision requires new equipment, or a change in equipment, at licensed smog check stations, the department shall provide a reasonable period of time for the acquisition and installation of that new or changed equipment.
(c) Notwithstanding any other provision of this chapter, the maximum emission standards and test procedures prescribed in subdivisions (a) and (b) for a motor vehicle class and model-year shall not be more stringent than the emission standards and test procedures under which that motor vehicle’s class and model-year was certified. Emission standards and test procedures prescribed by the department shall ensure that not more than 5 percent of the vehicles or engines, which would otherwise meet the requirements of this part, will fail the inspection and maintenance test for that class of vehicle or engine.
(d) Maximum emission standards established under this section shall not be adjusted downward based on the installation of an exhaust device.
(e) This section shall become inoperative five years from the date determined pursuant to Section 32 of the act adding this subdivision, and on the January 1 following that date is repealed.
History (another version listed by the Legislative Counsel)
Amended by Stats. 1994, Ch. 1192, Sec. 22. Effective January 1, 1995. Operative on date prescribed by Sec. 32 of Ch. 1192. Inoperative five years from operative date. Repealed on January 1 after inoperative date, by its own provisions. See later operative version added by Sec. 22.5 of Ch. 1192.
Another version listed by the Legislative Counsel
Section operative on date prescribed by its own provisions.
(a) (1) The department, in cooperation with the state board, shall prescribe maximum emission standards to be applied in inspecting motor vehicles under this chapter.
(2) In prescribing the standards, the department shall undertake studies and experiments which are necessary and feasible, evaluate available data, and confer with automotive engineers.
(3) The standards shall be set at a level reasonably achievable for each class and model of motor vehicle when operating in a reasonably sound mechanical condition, allowing for the effects of installed motor vehicle pollution control devices and the motor vehicle’s age and total mileage.
(4) The standards shall be designed so that motor vehicles failing the test specified in Section 44012 will be operated, as soon as possible, with a substantial reduction in emissions, and shall be revised from time to time as experience justifies.
(b) The department, in cooperation with the state board, shall research and prescribe test procedures to be applied in inspecting motor vehicles under this chapter, which procedures shall be simple, cost-effective, and consistent with Section 44012. The department may revise the test procedures from time to time as experience justifies. To the extent that any test procedure revision requires new equipment, or a change in equipment, at licensed smog check stations, the department shall provide a reasonable period of time for the acquisition and installation of that new or changed equipment.
(c) Notwithstanding any other provision of this chapter, the maximum emission standards and test procedures prescribed in subdivisions (a) and (b) for a motor vehicle class and model-year shall not be more stringent than the emission standards and test procedures under which that motor vehicle’s class and model-year was certified. Emission standards and test procedures prescribed by the department shall ensure that not more than 5 percent of the vehicles or engines, which would otherwise meet the requirements of this part, will fail the inspection and maintenance test for that class of vehicle or engine.
(d) This section shall become operative five years from the date determined pursuant to Section 32 of the act adding this section.
History (another version listed by the Legislative Counsel)
Repealed (in Sec. 22) and added by Stats. 1994, Ch. 1192, Sec. 22.5. Effective January 1, 1995. Section operative on date prescribed by its own provisions.
Source of truth
- Edition
- As published in the Legislative Counsel's database, tables dated October 18, 2026 (pubinfo_2025.zip)
- Official file
- https://leginfo.legislature.ca.gov/faces/codes_displaySection.xhtml?lawCode=HSC§ionNum=44013.
- Text hash
- sha256 666ffe8874638574dd706821e444055fbc32c084ba43131a5764c3d0849b7383
- Composed by
- compose_ca.py 2026-10-22: the Legislative Counsel's CAML content files read by a tokenizer (caml_readers.reader_a); an independent xml.etree reading (caml_readers.reader_b) agrees on every section
- the Legislative Counsel lists 3 versions of this section; the version shown is the one in force by its history, the other is under "Another version listed by the Legislative Counsel" (current)
- the Legislative Counsel lists 3 versions of this section; the version shown is the one in force by its history, the other is under "Another version listed by the Legislative Counsel" (current)
This section cites
Provisions in this library that the text above cites, as it prints each citation. A range cited as “ss. 61.13-61.16” links its first and last provisions.
Health and Safety Code
Cited by 2 provisions
Provisions in this library whose text cites Health & Saf. Code, § 44013. Each shows the citation as that text prints it.
Procedural information only. Not legal advice and not a substitute for the advice of an attorney. Confirm the current text with the official publisher before relying on it.