MOVING HEAVY EQUIPMENT AT RAILROAD GRADE CROSSINGS.

(a) This section applies only to:

(1) a crawler-type tractor, steam shovel, derrick, or roller; and

(2) any other equipment or structure with:

(A) a normal operating speed of 10 miles per hour or less; or

(B) a vertical body or load clearance of less than one-half inch per foot of the distance between two adjacent axles or less than nine inches measured above the level surface of a roadway.

(b) An operator of a vehicle or equipment may not move on or across a track at a railroad grade crossing unless the operator has given notice to a station agent of the railroad and given the railroad reasonable time to provide proper protection at the crossing.

(c) To move a vehicle or equipment on or across a track at a railroad grade crossing, the operator:

(1) shall stop the vehicle or equipment not closer than 15 feet or farther than 50 feet from the nearest rail of the railroad;

(2) while stopped, shall listen and look in both directions along the track for an approaching train or other on-track equipment and for signals indicating the approach of a train or other on-track equipment; and

(3) may not proceed until it is safe to cross the track.

(d) An operator of a vehicle or equipment may not cross a railroad grade crossing when warning of the immediate approach of a railroad car, train, or other on-track equipment is given by automatic signal, crossing gates, a flagger, or otherwise. If a flagger is provided by the railroad, the operator shall move the vehicle or equipment over the crossing at the flagger's direction.

(e) An offense under this section is punishable by a fine of not less than $50 or more than $200.